Maintenance of automatic capsule filling machine

How do we usually do a good job of automatic capsule filling machine maintenance? Here we look at those who should pay attention to.

Automatic Vacuum System Vacuum Separator In the filling of the hard capsule, the capsule is sucked into the upper and lower modules and the cap and body are separated. If the capsules can not be caped or removed, the subsequent filling will not be carried out. Automatic capsule filling machine turntable every operation of a station, the machine spindle rotation of a week, automatic capsule filling machine vacuum separator under the action of the cam on the next movement.

 

If the capsule cap, body separation is not smooth, should check the vacuum separator between the upper plane and the lower plane of the gap between the module, the gap is too large vacuum system vacuum can not reach the cap, body separation required vacuum, The gap is too small and prone to knock to make the next module deformation. When the position of the vacuum separator needs to be adjusted, use the handle to turn the main motor shaft of the fully automatic capsule filling machine to raise the vacuum separator to the highest position, loosen the locking nut at both ends of the adjusting rod under the machine table, and then adjust the adjustment lever Vacuum the height of the separator, then lock the nut and turn the main motor shaft test with the handle until it is appropriate. Vacuum degree in the machine operation panel vacuum gauge read out, the vacuum is too high may be appropriate to open the vacuum control valve, vacuum is too low can be turned off or close the vacuum control valve. Automatic Capsule Filling Machine Vacuum system filters should be cleaned regularly to clean up clogged dirt to ensure that the vacuum system has sufficient vacuum.