Simple troubleshooting of the automatic capsule filling machine

When an abnormal fault occurs, it may cause the "timing" error of each cam (ie, the timing of the operation of each cam is wrong), and adjust the motion to ensure that the movement does not interfere. When the motor needs to adjust the cam "timing" (that is, the cam action sequence), the application of the handle to turn the main motor shaft, when the filling turntable to reach the wheel, when the motor is driven by the reducer, When a station is used, the filling carousel is stopped by movement and continues for a period of time. During the period of time when the carousel is stopped, it shall be:

1) the first and second stations for the capsule delivery of the cam should be sent to the module on the mouth;

2) the first and second stations for the use of a vacuum separator so that the caps of the capsule cap and the body should rise to the lower plane of the lower module and cause the vacuum system to generate sufficient degree of vacuum to bring the capsule into the module and cap Body separation

3) the sixth station for the removal of the capsule will not be separated by the cam should be added to remove the residual capsule;

4) the eighth station for locking the capsule will be filled with the cam should be raised capsule;

5) Ninth station for the finished product to launch the cam should be rolled out of finished products.

6)After the intermittent period, fill the turntable began to move to the next station, during the movement should ensure that the movement of the agencies do not interfere, when the interference should see the cam action is too early or too late, when the cam action too early Should be loosened cam fastening screw to reverse the cam, when the cam action too late, should release the cam fastening screws to cam camouflage, in order to achieve the action of the agencies do not interfere. The cam "with time" should be adjusted after the handle with a continuous rotation of the main motor shaft to fill the turntable for a week or two, to confirm the movement of the agencies do not interfere, before the power to run the machine.

(7) electrical control system of the machine. There are three ways to run the machine: jog, auto and debug.

The difference between the automatic mode and the debugging mode is that when the automatic mode is selected, the four side doors of the work surface are closed to start the main motor. The main motor can be started when the four side doors of the work surface are opened when the debugging mode is selected. The main motor through the inverter stepless speed regulation, through the main contactor normally open contact to start and stop the inverter to start and stop the main motor.

The machine has a lack of hollow capsule and lack of drug particles automatic alarm system, when the lack of hollow capsule or drug particles, the alarm prompts the operator to add the material.

 Ruian City, the new machinery factory, the Company to produce automatic capsule filling machine and follow-up polishing, tick waste, a few tablets, filling and other series of equipment-based, best-selling products more than 30 provinces, municipalities and autonomous regions and Taiwan, Hong Kong , And other regions, and exported to Asia, Europe, the United States more than 40 countries, won the good reputation of customers, and establish a good corporate image. Welcome friends to consult, hotline: 0086-577-65026633 Guo dry 13396969696 Website: www.rarjjx.com