Maintenance of automatic hard capsule filling machine

(1) When the machine has a long working time, it is necessary to clean up the parts that are in direct contact with the drug on a regular basis and clean up when the batch is replaced or when the replacement time is longer.

(2) machine work platform under the transmission mechanism should always be appropriate to add lubricants (grease), in order to reduce the wear of moving parts.

(3) the main drive reducer to check the oil once a month, when the lack of timely refueling, every six months to replace the oil; turntable station sub-box for each operation 3000h to replace the oil, generally 90 # Oil.

(4) the safety clutch is in the machine overload protection, the load is normal when the clutch should not slip, but due to prolonged use may also be slipping phenomenon, when the normal use of the phenomenon of slip, the clutch can be round nut Tighten some, in order to ensure the normal operation of the machine can play a protective role.

(5) vacuum system vacuum separator in the filling of the hard capsule mainly play the capsule in the upper and lower modules and the cap and body separation effect, if the capsule can not cap, body separation, the subsequent filling will not be possible. Machine turntable for each operation of a station, the machine spindle rotation 1 week, the vacuum separator under the action of the cam on the next movement 1 times. If the capsule cap, body separation is not smooth, should check the vacuum separator between the upper plane and the lower plane of the gap between the module, the gap will be too large vacuum system can not reach the cap, body separation required vacuum ( 0.05MPa or so), the gap is too small and prone to collapse so that the next module deformation. When the position of the vacuum separator needs to be adjusted, turn the main motor shaft with the handle to raise the vacuum separator to the highest position, loosen the lock nut at both ends of the adjustment rod under the machine table (one for the left nut and one for the right nut ), Then adjust the height of the vacuum separator by rotating the lever, then lock the nut and turn the main motor shaft test with the handle until it is appropriate. Vacuum degree in the machine operation panel vacuum table read out, the vacuum is too high may be appropriate to open the vacuum control valve, vacuum is too low can be turned off or close the vacuum control valve. Vacuum system filters should be cleaned regularly to clean up clogged dirt to ensure that the vacuum system has sufficient vacuum.

(6) transmission chain should be checked once a week, and add the right amount of grease, it is necessary to re-tighten. When the chain is too loose need to re-tighten, you should move the tension wheel adjustment, but can not open the chain can not make the chain from the sprocket, so as not to disrupt the movement of the entire body sequence to prevent the movement of the organization interference.

(7) The machine has a total of five drive cams, five cams are installed on the main shaft of the machine, respectively, for the first and second stations for the capsule of the first cam, two stations for the use of vacuum separation A cam for removing the capsules, a cam for removing the capsules, and a cam for locking the filled capsules in the eighth station; The cam that will be finished.

Ruian Rijin Machinery Factory

Production and sales of automatic capsule filling machine and follow-up polishing, tick waste, a few tablets, filling and other series of equipment-based products selling more than 30 domestic provinces, municipalities and autonomous regions and Taiwan, Hong Kong, and other regions and exported to Asia , Europe, the United States more than 40 countries, won the good reputation of customers, and establish a good corporate image.

Welcome to call the hotline: 0577-65026633